ASTM-D374M › Historical Revision Information
Standard Test Methods for Thickness of Solid Electrical Insulation (Metric)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the determination of the thickness of several types of solid electrical insulating materials employing recommended techniques. Use these test methods except as otherwise required by a material specification.
1.2 The values stated in SI units are the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Electrical insulating solids; Electrical properties; Plast (electrical insulating); Plast (general)-electroplated; Plastic sheet and film; Rubber-electrical insulating; Thickness-electrical insulating materials; thickness-solid electrical insulation, test; ICS Number Code 29.035.01 (Insulating materials in general)
To find similar documents by ASTM Volume:
10.01 (Electrical Insulation (I): D69 - D2484)
To find similar documents by classification:
29.035.01 (Insulating materials in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D374M-99
Revision Level
1999 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 10, 1999
Document Type
Test Method
Page Count
11 pages
Committee Number
D09.12