ASTM-D3776 › Historical Revision Information
Standard Test Methods for Mass Per Unit Area (Weight) of Fabric
The following bibliographic material is provided to assist you with your purchasing decision:
These test methods cover the measurement of fabric mass per unit area (weight) and is applicable to most fabrics. There are four approved options in the measurement of fabric mass per unit area: Option A, Option B, Option C, and Option D. Option A may be used for acceptance testing of commercial shipments since it has been used extensively in the trade. The second option is Option B which is applicable to a full-width sample cut from a full piece, roll, bolt, or cut. Unless otherwise specified, these results will include selvages and will be on the basis of conditioned fabric. Option C on the other hand is applicable when a small swatch of fabric is sent to the laboratory to be used as the test specimen. The results are considered to be applicable to the sample only and not necessarily to the lot from which the sample was taken. Measurements by this method do not include selvages and should be reported as such, unless a selvage allowance is specified. The last option is Option D which is intended for use with narrow fabrics as so designated by the trade.
Scope
1.1 These test methods cover the measurement of fabric mass per unit area (weight) and is applicable to most fabrics.
1.2 There are four approved options:
1.2.1 Option A—Full Piece, Roll, Bolt or Cut (Section 7).
1.2.2 Option B—Full Width Sample (Section 8).
1.2.3 Option C—Small Swatch of Fabric (Section 9).
1.2.4 Option D—Narrow Fabrics (Section 10).
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
fabric; mass per unit area; weight: Mass per unit area; Weight per unit area; Woven textile fabrics; ICS Number Code 59.080.30 (Textile fabrics)
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
07.02 (Textiles (II): D4393 - latest)
To find similar documents by classification:
59.080.30 (Textile fabrics Including nonwovens, felts, lace, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3776/D3776M-09ae2
Revision Level
2009A(E2) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Sept. 15, 2011
Document Type
Test Method
Page Count
5 pages
Committee Number
D13.60