ASTM-D3896 › Historical Revision Information
Standard Practice for Rubber From Synthetic Sources-Sampling
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice, intended for referee purposes, covers a uniform procedure for sampling lots of solid synthetic rubbers. Raw synthetic rubber generally is marketed in bales or packages of various sizes.
1.2 A procedure for determining the acceptability of lots of synthetic rubber is given. This procedure is based on a variables sampling plan.
1.3 The sample size is based on the assumption of a visually homogeneous material. If obvious heterogeneity exists, the number of samples shall be increased.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The sampling plan is intended for referee purposes only in establishing the properties or quality of a lot or shipment of synthetic rubber.
Keywords
sampling; synthetic rubber; ICS Number Code 83.060 (Rubber)
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.040.01 (Raw materials for rubber and plastics in general)
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3896-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 1, 2007
Document Type
Practice
Page Count
2 pages
Committee Number
D11.23