ASTM-D3900 › Historical Revision Information
Standard Test Methods for Rubber - Determination of Ethylene Units in Ethylene-Propylene Copolymers (EPM) and in Ethylene-Propylene-Diene Terpolymers (EPDM) by Infrared Spectrometry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These infrared test methods cover the determination of the proportion of ethylene and propylene units in ethylene-propylene copolymers (EPM) and ethylene-propylenediene terpolymers (EPDM) over the range from 35 to 85 mass % ethylene. Four test methods are needed to encompass the variety of commercial polymers that contain additives or polymerized diene units that interfere with the various infrared peaks. Except when interferences are present, all four test methods should give similar results. The test methods appear in the following order:
1.1.1 Pressed Film Test Methods
| Sections | |
| Test Method A-For EPM and EPDM between 35 and 65 mass % ethylene | 8-13 |
| Test Method B-For EPM and EPDM between 60 and 85 mass % ethylene, except for ethylene/propylene/1,4-hexadiene terpolymers | 14-18 |
| Test Method C-For all EPM and EPDM polymers between 35 and 85 mass % ethylene, using near infrared | 24-31 |
1.1.2 Cast Film Test Methods:
| Test Method D-For all EPM and EPDM polymers between 35 and 85 mass % ethylene, except for ethylene/propylene/1,4-hexadiene terpolymers | 24-31 |
1.2 These test methods are not applicable to oil-extended EPDM unless the oil is first removed in accordance with Test Method D.
1.3 The values stated in SI units are to be regarded as the standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
ethylene-propylene copolymers; ethylene-propylene-diene terpolymers; infrared; ICS Number Code 83.040.10 (Latex and raw rubber)
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.040.10 (Latex and raw rubber)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3900-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Feb. 15, 1994
Document Type
Test Method
Page Count
9 pages
Committee Number
D11.11