ASTM-D3910 › Historical Revision Information
Standard Practices for Design, Testing, and Construction of Slurry Seal
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These practices cover the design, testing, and construction of mixtures for surface treatment of pavements. It is written as a guide and should be used as such. End-use specifications should be adapted to conform to job and user requirements.
1.2 The values stated in SI units are to be regarded as the standard. The non-SI units used in this standard are allowed by the sub-committee for clarification in the use of the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 These slurry seal practices are written as a guide and should not be construed as specifications.
4.2 End-use specifications should be adopted to conform to job and user requirements.
Keywords
abrasion resistance; appropriate ratio-mix formula; emulsified asphalt cold mixure; fine-graded aggregate; mineral filler; mixing water; set and cure time; slurry consistency; slurry seal ; specialized mixing and application equipment;
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
93.080.10 (Road construction Including road maintenance equipment and road construction equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3910-15
Revision Level
2015 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 1, 2015
Document Type
Practice
Page Count
8 pages
Committee Number
D04.24