ASTM-D3912 › Historical Revision Information
Standard Test Method for Chemical Resistance of Coatings and Linings for Use in Nuclear Power Plants
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method establishes procedures for the evaluation of the chemical resistance of coatings used in light-water nuclear power plants.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
chemical resistance; coatings and linings; nuclear
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3912-80
Revision Level
1980 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 30, 1980
Document Type
Test Method
Page Count
3 pages
Committee Number
D33.02