ASTM-D4014 › Historical Revision Information
Standard Specification for Plain and Steel-Laminated Elastomeric Bearings for Bridges
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers bearings, which consist of all elastomer or of alternate laminates of elastomer and steel, when the function of the bearings is to transfer loads or accommodate relative movement between a bridge superstructure and its supporting structure, or both.
1.2 The values stated in SI units are to be regarded as the standard.
Note 1—The words "elastomer" or "elastomeric" will be used interchangeably with the word "rubber" in this specification.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section B, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
bearings; elastomer; bridge superstructure; elastomeric; rubber; sandwich bearing; ICS Number Code 93.040 (Bridge construction)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4014-89
Revision Level
1989 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 27, 1989
Document Type
Specification
Page Count
6 pages
Committee Number
D04.32