ASTM-D412 › Historical Revision Information
Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers - Tension
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods describe procedures used to evaluate the tensile (tension) properties of vulcanized rubbers and thermoplastic rubbers and thermoplastic elastomers. The test methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:
Test Method A-Dumbbell and Straight Section Specimens; Test Method B-Cut Ring Specimens
Note 1- these two different methods do not produce identical results.
1.2 The values stated in either SI or non-SI units shall be regarded separately as normative for this standard. The values in each system may not be exact equivalents; therefore each system must be used independently, without combining values.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
elongation; set after break; tensile properties; tensile set; tensile strength; tensile stress; yield point
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D412-87
Revision Level
1987 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 27, 1987
Document Type
Test Method
Page Count
17 pages
Committee Number
D11.10