ASTM-D4142 › Historical Revision Information
Standard Guide for Testing Epoxy Resins
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide covers methods for testing epoxy resins as listed in Table 1. All of the methods were tested by interlaboratory participation in accordance with usual ASTM guidelines. Each method specifies a recommended amount of sample for starting a separate analysis, but several of the procedures can be conducted on the same starting material if so desired. For example, viscosity, color, and density could be run on the same specimen.
1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This guide directs the user to test methods that determine properties generally accepted as standard test items for classification of epoxy resins.
Keywords
epoxy resins; ICS Number Code 83.080.10 (Thermosetting materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4142-89
Revision Level
1989 EDITION
Status
Superseded
Publication Date
April 28, 1989
Document Type
Guide
Page Count
2 pages
Committee Number
D01.33