ASTM-D4143 › Historical Revision Information
Standard Guide for Testing Latex Vehicles
The following bibliographic material is provided to assist you with your purchasing decision:
This guide details the standard methods suitable for testing latex vehicles. Included here are methods for latex sampling, nonvolatile content, minimum film formation temperature, qualitative polymeric analysis, density, viscosity, consistency, water content, pH, and surface tension.
Scope
1.1 This guide covers methods suitable for testing latex vehicles. Certain of these methods were developed expressly for testing latex vehicles. Others were developed for testing or analyzing formulated water- or solvent-based coatings but would be equally applicable for testing lattices.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
latex vehicles; lattices; Latex paints--selection and use of test procedures; Testing methods--paints/related coatings; ICS Number Code 87.060.20 (Binders)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4143-89(2009)
Revision Level
1989 R09 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 30, 2009
Document Type
Guide
Page Count
2 pages
Committee Number
D01.33