ASTM-D4188 Historical Revision Information
Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test

ASTM-D4188 - 1982 R03 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water
ORDER

Scope

1.1 This practice covers the procedure used to perform pressure in-line coagulation-flocculation-filtration of water and waste water. It is applicable to water and waste water with relatively low suspended solids (< 30 mg/L). The practice is applicable for any size filter greater than 100 mm (4 in.) in diameter.

1.2 This practice can be used to determine the effectiveness of flocculants or coagulants, or both, and filter medium(a) in removing suspended and colloidal material from water and waste water.

1.3 Interval between filter backwashing, backwash requirements, rinse requirements, and effect of filtration rate on effluent quality can also be obtained with this practice.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Pressure in-line coagulation-flocculation followed by filtration is an effective process to remove suspended and colloidal matter from water and waste water.

The effectiveness of this process is dependent on the type and concentration of the flocculant or coagulant, or both, the pH, the temperature, the filtration medium(a), and the filtration rate. This practice permits the evaluation of these various parameters.

This practice can also be used to determine filter backwash and rinse requirements.

The results obtained from this practice can be used for plant design of large systems.

Keywords

coagulation-flocculation; colloidal dispersions; effluents; filters/filter procedures-water testing; flocculation; pessure testing-water applications; wastewater testing/treatment; water; pressure in-line coagulation-flocculation-filtration; ICS Number Code 13.060.30 (Sewage water)

To find similar documents by ASTM Volume:

11.01 (Water (I))

To find similar documents by classification:

13.060.30 (Sewage water Including sewage water disposal and treatment Liquid wastes, see 13.030.20 Drainage systems, see 91.140.80 Sewage systems, see 93.030)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D4188-82(2003)

Revision Level

1982 R03 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Dec. 1, 2003

Document Type

Practice

Page Count

4 pages

Committee Number

D19.03