ASTM-D4189 › Historical Revision Information
Standard Test Method for Silt Density Index (SDI) of Water
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the silt density index (SDI) of water. This test method can be used to indicate the quantity of particulate matter in water and is applicable to relatively low (∧lt;1.0 NTU) turbidity waters such as well water, filtered water, or clarified effluent samples. Since the size, shape, and nature of particulate matter in water may vary, this test method is not an absolute measurement of the quantity of particulate matter.
1.2 This test method is not applicable for reagent grade water Types I, II, and III of Specification D1193, or effluents from most reverse osmosis and ultrafiltration systems.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use .
Keywords
Density; Filters/filter procedures-water testing; Particle analysis-water; Reverse osmosis (RO) installations; SDI (silt density index); Silt density index (SDI); Water; silt density index (SDI) of water, test
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.060.70 (Examination of biological properties of water Microbiology of water, see 07.100.20)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4189-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 15, 1995
Document Type
Test Method
Page Count
3 pages
Committee Number
D19.08