ASTM-D4242 › Historical Revision Information
Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method specifies a method for determining the flow characteristics of a fused thermosetting coating powder down a plane inclined at a set angle to the horizontal. The test gives an indication of the degree of melt flow that may occur during the curing of the coating powder. This characteristic contributes to the coherence of the coating, to its surface appearance and to the degree of coverage over sharp edges, however, it should not be used as the sole factor for judgment. The test acts as a useful method for checking for batch to batch variation in the behavior of a given coating powder. Correlation between the results from coating powders of differing composition is not to be expected. This method is unlikely to yield meaningful results with coating powders which have gel times of less than one minute at the test temperature (see Test Method D 4217.)
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
Keywords
coating powder; pill flow of coating powder; plate flow of coating powder; ICS Number Code 83.080.10 (Thermosetting materials)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4242-83
Revision Level
1983 EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
April 29, 1983
Document Type
Test Method
Page Count
4 pages
Committee Number
D01.51