ASTM-D4315 › Historical Revision Information
Standard Test Methods for Rubber Compounding Material-Zinc Oxide
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover chemical and physical tests for zinc oxide that are considered to be important to its use in rubber compounding.
1.2 The tests appear in the following order:
Test | Section |
Zinc Oxide | 5 |
Lead and Cadmium | 6 |
Sulfur | 7 |
Heat Loss | 8 |
Surface Area | 9 |
Sieve Residue | 10 |
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use For specific precautions, see 5.2.
Keywords
chemical and physical tests for zinc oxide; heat loss; lead and cadmium in zinc oxide; sieve residue; sulfur in zinc oxide; surface area; zinc oxide; zinc oxide percent
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.040.20 (Rubber compounding ingredients Including carbon black, kaolin clay, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4315-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 15, 1994
Document Type
Test Method
Page Count
2 pages
Committee Number
D11.20