Document Center is acquired by Nimonik

Scope

1.1 This (laboratory) test method is used for determining the minimum concentration of fungicide, or formulation of fungicides, that is effective in preventing biodeterioration by sapstain fungi and molds in selected species of wood under optimum laboratory conditions.

Note 1—From the results of this test, commercial treating solution concentrations cannot be estimated without further field tests.

1.2 The requirements for test materials and procedures are discussed in the following order:

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is useful as a screening procedure for selecting fungicides or formulations for more rigorous field evaluation.

Keywords

fungicides; lumber; mold; sapstain; test method; Discoloration; Fungal influence/resistance; Lumber; Molds; Sapstain control; Spore suspension; Surface analysis--building construction materials/insulation; Toxicity/toxicology; ICS Number Code 79.040 (Wood, sawlogs and sawn timber)

To find similar documents by ASTM Volume:

04.10 (Wood)

To find similar documents by classification:

79.040 (Wood, sawlogs and sawn timber)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.