ASTM-D4618 Historical Revision Information
Design & Fabrication of Flue Gas Desulfurization System Components for Protective Lining A

ASTM-D4618 - 1987 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Design and Fabrication of Flue Gas Desulfurization System Components for Protective Lining Application
ORDER

Scope

1.1 This specification covers the design and fabrication of metal components for Flue Gas Desulfurization (FGD) equipment, including absorbers, tanks, chimney liners, ductwork and associated equipment that are to be lined for corrosion or abrasion resistance, or both.

1.2 Limitations

1.2.1 This specification is intended only to define the design considerations for successful application and performance of protective linings for FGD system components.

1.2.2 It does not cover structural performance of FGD components.

1.2.3 It does not cover use of metalic linings.

1.3 This specification represents the minimum requirements for lining work. In cases where the manufacturer's instructions and recommendations differ from this specification, these differences must be resolved before fabrication is started.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Atmospheric analysis; Design-building applications; Desulfurization systems; Fabrication; Flue gas desulfurization (FGD); Inspection-coating applications; Lining industry; Nuclear reactor vessels-coatings applications; Power generating facilities; Protective linings; Welding/welds; flue gas desulfurization system components-design/fabrication for; protective lining application, spec

To find similar documents by ASTM Volume:

06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)

To find similar documents by classification:

13.040.40 (Stationary source emissions)

27.100 (Power stations in general Including thermal power plants Nuclear power plants, see 27.120.20 Hydraulic power plants, see 27.140 Solar power stations, see 27.160 Wind turbine systems, see 27.180)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D4618-87

Revision Level

1987 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Feb. 20, 1987

Document Type

Specification

Page Count

7 pages

Committee Number

D33.09