Document Center is acquired by Nimonik

Scope

1.1 This test method describes a procedure for determining the sorption affinity of waste solutes by unconsolidated geologic material in aqueous suspension. The waste solute may be derived from a variety of sources such as wells, underdrain systems, or laboratory solutions such as those produced by waste extraction tests like the Method D3987 shake extraction method.

1.2 This test method is applicable in screening and providing relative rankings of a large number of geomedia samples for their sorption affinity in aqueous leachate/geomedia suspensions. This test method may not exactly simulate sorption characteristics that would occur in unperturbed geologic settings.

1.3 While this procedure may be applicable to both organic and inorganic constituents, care must be taken with respect to the stability of the particular constituents and their possible losses from solution by such processes as degradation by microbes, light, or hydrolysis. This test method should not be used for volatile chemical constituents (see 6.1).

1.4 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is meant to allow for a rapid (24 h) index of a geomedia’sorption affinity for given chemicals or leachate constituents. A large number of samples may be run using this test method to determine a comparative ranking of those samples, based upon the amount of solute sorbed by the geomedia, or by various geomedia or leachate constituents. The 24-h time is used to make the test convenient and also to minimize microbial degradation which may be a problem in longer-timed procedures. While K_d values are directly applicable for screening and comparative ranking purposes, their use in predictive field applications generally requires the assumption that K_d be a fixed value.

While this test method may be useful in determining 24-h K_d values for nonvolatile organic constituents, interlaboratory testing has been carried out only for the nonvolatile inorganic species, arsenic and cadmium. However, the procedure has been tested for single laboratory precision with polychlorinated biphenyls (PCBs) and is believed to be useful for all stable and nonvolatile inorganic, and organic constituents. This test method is not considered appropriate for volatile constituents.

The 24-h time limit may be sufficient to reach a steady-state K_d. However, to report this determination as a steady-state K_d, this test method should be conducted for intermediate times (for example, 12, 18 and 22 h) to ensure that the soluble concentrations in the solution have reached a steady state by 24 h. Refer to Test Method D 4319 for an alternate procedure of longer duration.

Keywords

absorption-soil/rock; accelerated aging/testing; biological data analysis-sediments; breaking strength/tenacity; chemical analysis-water applications; chemical-resistant materials/products; chemicals; contamination-environmental; distribution; hazard testing; ICS Number Code 13.080.05 (Examination of soil in general)

To find similar documents by ASTM Volume:

11.04 (Waste Management)

To find similar documents by classification:

13.080.05 (Examination of soils in general Including sampling)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.