ASTM-D4658 › Historical Revision Information
Standard Test Method for Sulfide Ion in Water (Withdrawn 2024)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method uses an ion-selective electrode to determine sulfide ion in water. The test method is applicable in the range from 0.04 to 4000 mg/L of sulfide.
1.2 Precision data presented in this test method were obtained using reagent water only. It is the user's responsibility to ensure the validity of this test method for untested types of water.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limits prior to use. Sulfide samples, when acidified, can release highly toxic hydrogen sulfide (H2S) gas. For a specific precautionary statement, see Note 2.
Keywords
Ion selective electrode method; Sulfide content; Water-inorganic constituents; sulfide ion in water, test
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.060.50 (Examination of water for chemical substances)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4658
Revision Level
WITHDRAWN
Status
Cancelled
Modification Type
Reapproval
Publication Date
Jan. 5, 2024
Document Type
Test Method
Committee Number
D19.05