ASTM-D4778 › Historical Revision Information
Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method provides directions for fabricating and operating a test apparatus to simultaneously monitor the corrosion and fouling tendency of real and pilot cooling water systems under heat transfer conditions.
1.2 Interpretation of the results of this test method must be left to the investigator. Many variables are involved which may not be easily controlled or fully understood. Variations in design and operating conditions may produce results that are not comparable from unit to unit.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cooling water; corrosion; deposits; fouling; heat transfer; ICS Number Code 13.060.60 (Examination of water for physical properties)
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.060.60 (Examination of physical properties of water)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4778-88(1993)e1
Revision Level
1988 R93(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
May 1, 1993
Document Type
Test Method
Page Count
5 pages
Committee Number
D19.03