Document Center is acquired by Nimonik

Scope

1.1 This test method provides directions for fabricating and operating a test apparatus to simultaneously monitor the corrosion and fouling tendency of real and pilot cooling water systems under heat transfer conditions.

1.2 Interpretation of the results of this test method must be left to the investigator. Many variables are involved which may not be easily controlled or fully understood. Variations in design and operating conditions may produce results that are not comparable from unit to unit.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Deposits on heat transfer surfaces reduce efficiency of the heat exchanger affected. A method for easily determining the corrosion and fouling tendency of a particular water under heat transfer conditions will allow the evaluation of changes in the various system variables such as heat flux, flow velocity, metallurgy, cycles-of-concentration, and treatment schemes on heat exchanger performance.

Note—All pipe is threaded 1 in. (25 mm) PVC. Heater should be fused and grounded in accordance with local electrical codes.

Parts List:
(1) test specimen	(6) acrylic tube, 10 in. (25 cm) long by 1 in. (25 mm) outside Diameter
(2) tube fitting; nylon (no metal parts)	(7) Cartridge type heater (not shown)
(3) reduci ng bushing, PVC
(4) tee, 1 in. (25 mm) PVC
(5) tube fitting, 1 in. (25 mm) tube by 1 in. (25 mm) male pipe thread stainless steel

Keywords

cooling water; corrosion; deposits; fouling; heat transfer; ICS Number Code 13.060.60 (Examination of water for physical properties)

To find similar documents by ASTM Volume:

11.01 (Water (I))

To find similar documents by classification:

13.060.60 (Examination of physical properties of water)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.