ASTM-D4786 › Historical Revision Information
Standard Test Method for Stitch Tear Strength, Single Hole
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is intended for determining the stitch-tearing strength of leather with a tear originating from one hole. It is particularly applicable to heavy leather. This test method does not apply to wet blue.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is intended to be used to rate leathers as to their stitch tear strengths.
Keywords
leather; stitch tear strength; tear strength; Heavy leather; Holes; Leather; Single hole leather; Stitch tear strength; Tear testing--leather; ICS Number Code 59.080.30 (Textile fabrics)
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
59.080.30 (Textile fabrics Including nonwovens, felts, lace, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4786-00(2010)
Revision Level
2000 R10 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 1, 2010
Document Type
Test Method
Page Count
2 pages
Committee Number
D31.01