Document Center is acquired by Nimonik

Scope

1.1 This test method describes a procedure using a high-temperature tube furnace and infrared detection for the determination of sulfur in coal and coke combustion residues, including lab ashes and residues from coal and coke combustion.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The percent sulfur content of the ash derived from coal or coke can be calculated to sulfur trioxide content. This information can be used in combination with results from the determination of major, minor and or trace elements in the same ash to calculate results on a sulfur trioxide free-basis or to calculate total recovered analyte.

Keywords

coal ash; coke ash; sulfur; Ash--coal/coke; Coal/coke products--chemical analysis; Coke; Combustion--coal processes; Furnaces; Infrared (IR) analysis; Infrared spectrometry; Infrared spectrophotometry; Infrared spectroscopy; Sulfur--coal/coke; Sulfur trioxide (SO3); Temperature tests--coal/coke; ICS Number Code 75.160.10 (Solid fuels)

To find similar documents by ASTM Volume:

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

75.160.10 (Solid fuels Including coal products, coke, peat, wood, derivatives of coal pyrolysis, etc. Coals, see 73.040)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.