Document Center is acquired by Nimonik

Scope

1.1 This test method covers both volumetric and gravimetric determination of resin solution dilutability which gives a numerical value for the overall solubility of the resin expressed as percent dilutability.

1.2 This test method is applicable only if the test solution is of sufficient clarity to allow accurate visual judgement of the end point and of low enough viscosity for efficient mixing to take place.

1.3 This test method is primarily for, but not limited to, resins used in the printing ink industry.

1.4 The percent solvent tolerance of a resin can be determined using this test method if the solvent in the resin solution and the dilution solvent are the same.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method provides a means for resin producers and users as well as solvent and varnish manufacturers to rate various types of resins for solubility by assigning a numerical dilutability value. This percent dilutability value can be used to differentiate resin types for end users and can be utilized as a quality control tool by resin manufacturers.

When running a series of these tests, the same lot or batch of dilution solvent must be used throughout to ensure reproducible results.

Keywords

dilutability value; percent dilutability; printing ink resins; resins; resin solution cloud point; resin solution dilutability; solvent tolerance; Dilutability value; Gravimetric determination; Percent dilutability; Printing ink resins; Printing inks/vehicles; Resins; Resin solution cloud point; Resin solutions; Solubility; Solvent tolerance; Titrimetric method; Turbidity; ICS Number Code 87.060.20 (Binders)

To find similar documents by ASTM Volume:

06.03 (Paint -- Pigments, Drying Oils, Polymers, Resins, Naval Stores, Cellulosic Esters, and Ink Vehicles)

To find similar documents by classification:

87.060.20 (Binders)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.