ASTM-D5129 Historical Revision Information
Standard Test Method for Open Channel Flow Measurement of Water Indirectly by Using Width Contractions

ASTM-D5129 - 1995 R03 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Open Channel Flow Measurement of Water Indirectly by Using Width Contractions (Withdrawn 2023)
ORDER

Scope

1.1 This test method covers the computation of discharge (the volume rate of flow) of water in open channels or streams using bridges that cause width contractions as metering devices.

1.2 This test method produces the maximum discharge for one flow event, usually a specific flood. The computed discharge may be used to help define the high-water portion of a stage-discharge relation.

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is particularly useful to determine the discharge when it cannot be measured directly by some type of current meter to obtain velocities and with sounding weights to determine the cross section.

Even under the best conditions, the personnel available cannot cover all points of interest during a major flood. The engineer or technician cannot always obtain reliable results by direct methods if the stage is rising or falling very rapidly, if flowing ice or debris interferes with depth or velocity measurements, or if the cross section of an alluvial channel is scouring or filling significantly.

Under the worst conditions, access roads are blocked, cableways and bridges may be washed out, and knowledge of the flood frequently comes too late. Therefore, some type of indirect measurement is necessary. The contracted-opening method is commonly used on valley-floor streams.

Keywords

flood; open channel flow; water discharge

To find similar documents by ASTM Volume:

11.01 (Water (I))

To find similar documents by classification:

17.120.20 (Flow in open channels Including hydrometric determinations)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5129-95(2003)

Revision Level

1995 R03 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

June 10, 2003

Document Type

Test Method

Page Count

42 pages

Committee Number

D19.07