ASTM-D516 › Historical Revision Information
Standard Test Method for Sulfate Ion in Water
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This turbidimetric test method covers the determination of sulfate in water in the range from 1 to 40 mg/L of sulfate ion (SO 4).
1.2 This test method was used successfully with drinking, ground, and surface waters. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.
1.3 Former gravimetric and volumetric test methods have been discontinued. Refer to Appendix X1 for historical information.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
drinking water; ground water; sulfate; surface water; turbidimetric; ICS Number Code 13.060.50 (Examination of water for chemical substances)
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.060.50 (Examination of water for chemical substances)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D516-02
Revision Level
2002 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 10, 2002
Document Type
Test Method
Page Count
4 pages
Committee Number
D19.05