Document Center is acquired by Nimonik

Scope

1.1 This practice covers the general principles to be followed when compression molding test specimens of thermosetting molding compounds, such as phenolics, aminoplastics, melamine phenolics, epoxies, and unsaturated polyesters.

Note 1--This standard is similar in content (but not technically equivalent) to ISO 295-1974 (E).

1.2 Molding conditions are given for amino, phenolic, and allyl molding compounds. Materials specification standards should always be consulted to determine whether the material to be molded has any special requirements.

1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

allyl molding compound; amino molding compound; compression molding; phenolic molding compound; plast; thermoset; ICS Number Code 77.180 (Equipment for the metallurgical industry)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

77.180 (Equipment for the metallurgical industry)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.