ASTM-D5288 › Historical Revision Information
Standard Test Method for Determining the Tracking Index of Electrical Insulating Materials Using Various Electrode Materials (Excluding Platinum)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method was developed using copper electrodes to evaluate the low-voltage (up to 600 V) tracking resistance of materials in the presence of aqueous contaminants.
Note 1-At this time, only industrial laminates have been examined using this method which was developed at the National Manufacturers Electrical Association (NEMA) laboratory located at the University of Cincinnati. It was found that a closer end point (less scatter) was obtained than with platinum electrodes, and materials tested tended to be ranked by resin system.1.1.1 Other electrode materials may be considered for use with this test method depending upon the application of the insulating material.
1.2 This test method is similar to Test Method D3638, which determines the comparative tracking index of materials using platinum electrodes to produce the tracking on the specimen surface.
1.3 The values stated in metric (SI) units are the standard. The inch-pound equivalents of the metric units are approximate.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
copper electrodes; comparative tracking index; CTI; CTI-Cu; TI; track; tracking, contamination; tracking index; tracking resistance; ICS Number Code 29.035.01 (Insulating materials in general)
To find similar documents by ASTM Volume:
10.02 (Electrical Insulation (II): D2518 - latest)
To find similar documents by classification:
29.035.01 (Insulating materials in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5288-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1997
Document Type
Test Method
Page Count
5 pages
Committee Number
D09.12