Document Center is acquired by Nimonik

Scope

1.1 This specification covers polyphthalamide materials suitable for injection molding.

1.2 The properties included in this specification are those required to identify the compositions covered. Other requirements necessary to identify particular characteristics important to specialized applications are to be specified by using suffixes as given in Section 5. See Guide D 5740.

1.3 This specification allows for the use of recycled materials provided that all specification requirements are met.

1.4 This specification is intended to be a means of calling out plastics materials used in the fabrication of end items or parts. It is not intended for the selection of materials. Material selection can be made by those having expertise in the plastics field only after careful consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the costs involved, and the inherent properties of the material other than those covered by this specification.

1.5 The values stated in SI units are to be regarded as the standard (see IEEE/ASTM SI-10). The values given in parentheses are for information only.

1.6 The following precautionary caveat pertains only to the test methods portion, Section 12, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Note 6.

Note 1—There is no known ISO equivalent to this specification.

Keywords

inherent viscosity; line call-out; moisture analysis; molding material; plastic; polyphthalamide; Inherent viscosity; Line call-out specifications--plastics; Moisture analysis--plastics; Molding/extrusion compounds/materials--specifications; Polyphthalamide (PPA); Viscosity--plastics

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.140.99 (Other rubber and plastics products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.