ASTM-D5365 › Historical Revision Information
Standard Test Method for Long-Term Ring-Bending Strain of "Fiberglass" (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a procedure for determining the long-term ring-bending strain (S b) of "fiberglass" pipe. Both glass-fiber-reinforced thermosetting-resin pipe (RTRP) and glass-fiber-reinforced polymer mortar pipe (RPMP) are "fiberglass" pipes.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific warning statement is given in 9.5.
Note 1—There is no similar or equivalent ISO standard.
Keywords
constant load; deflection; end point; fiberglass pipe; pipe-ring specimens; regression line; ring-bending strain; ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5365-01e1
Revision Level
2001(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Nov. 1, 2004
Document Type
Test Method
Page Count
8 pages
Committee Number
D20.23