ASTM-D5449 › Historical Revision Information
Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method determines the transverse compressive properties of wound polymer matrix composites reinforced by high-modulus continuous fibers. It describes testing of hoop wound (90o
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
composite materials; filament winding; Poisson's ratio; transverse compressive properties; transverse compressive strength; transverse modulus of elasticity; tubes; ICS Number Code 83.140.20 (Laminated sheets)
To find similar documents by ASTM Volume:
15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5449/D5449M-93(2000)
Revision Level
1993 R00 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Aug. 15, 1993
Document Type
Test Method
Page Count
9 pages
Committee Number
D30.04