ASTM-D5449 › Historical Revision Information
Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method determines the transverse compressive properties of wound polymer matrix composites reinforced by high-modulus continuous fibers. It describes testing of hoop wound (90) cylinders in axial compression for determination of transverse compressive properties.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is designed to produce transverse compressive property data for material specifications, research and development, quality assurance, and structural design and analysis. Factors that influence the transverse compressive response and should therefore be reported are: material, method of material preparation, specimen preparation, specimen conditioning, environment of testing, specimen alignment and gripping, speed of testing, void content, and fiber volume fraction. Properties in the test direction that may be obtained from this test method are:
5.1.1 Transverse compressive strength, σ22uc,
5.1.2 Transverse compressive strain at failure, ε22uc,
5.1.3 Transverse compressive modulus of elasticity, E22, and
5.1.4 Poisson’ratio, γ21.
Keywords
composite materials; filament winding; Poisson's ratio; transverse compressive properties; transverse compressive strength; transverse modulus of elasticity; tubes; ICS Number Code 83.140.20 (Laminated sheets)
To find similar documents by ASTM Volume:
15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5449/D5449M-11
Revision Level
2011 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 1, 2012
Document Type
Test Method
Page Count
10 pages
Committee Number
D30.04