ASTM-D5478 › Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the measurement of the viscosity of Newtonian and non-Newtonian liquids. These test methods are applicable to liquids having viscosities in the range from 5 X 10 -4 to 10 Pa[dot]s (0.5 to 10 cP). The shear rate range is dependent upon the needle used and viscosity of the liquid and may vary from 10 -4 to 10 s -1 .
1.2 The yield stress of liquids having this property may also be determined.
1.3 These test methods consist of determining liquid viscosities of Newtonian and non-Newtonian fluids (clear or opaque) by measuring the steady-state (constant) or terminal velocities of cylindrical needles as they fall through the test liquid under the influence of gravity. Yield stresses of non-Newtonian liquids may be measured using the same procedure.
Keywords
falling needle viscometer; Newtonian fluid; non-Newtonian fluid; rheological property; rheometer; viscometer; viscosity; yield stress; ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5478-13R22
Revision Level
2013 R22 EDITION
Status
Current
Modification Type
Revision
Publication Date
Dec. 15, 2022
Document Type
Test Method
Page Count
5 pages
Committee Number
D01.24