ASTM-D5581 › Historical Revision Information
Standard Test Method for Resistance to Plastic Flow of Bituminous Mixtures Using Marshall Apparatus (6 inch-Diameter Specimen)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the resistance to plastic flow of cylindrical specimens of bituminous paving mixture loaded on the lateral surface by means of the Marshall apparatus. This test method is for use with mixtures containing asphalt cement and aggregate up to 1 1/2 in. (37.5 mm) nominal maximum size.
1.2 The values stated in inch-pound units are to be regarded as standard except for reference to sieve sizes and size of aggregate as measured by testing sieves in which SI units are standard according to Specification E11. The SI equivalent shown in parentheses may be approximate.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
bituminous paving mixtures; compaction flow; plastic flow resistance; resistance; plastic flow resistance-bituminous paving mixtures, using Marshall; apparatus (6 in. diameter specimen),; ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5581-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Sept. 15, 1994
Document Type
Test Method
Page Count
5 pages
Committee Number
D04.20