Document Center is acquired by Nimonik

Scope

1.1 This test method covers the measurement of the resistance to plastic flow of cylindrical specimens of bituminous paving mixture loaded on the lateral surface by means of the Marshall apparatus. This test method is for use with mixtures containing asphalt cement and aggregate up to 1 1/2 in. (37.5 mm) nominal maximum size.

1.2 The values stated in inch-pound units are to be regarded as standard except for reference to sieve sizes and size of aggregate as measured by testing sieves in which SI units are standard according to Specification E11. The SI equivalent shown in parentheses may be approximate.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

bituminous paving mixtures; compaction flow; plastic flow resistance; resistance; plastic flow resistance-bituminous paving mixtures, using Marshall; apparatus (6 in. diameter specimen),; ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)

To find similar documents by ASTM Volume:

04.03 (Road and Paving Materials; Vehicle-Pavement Systems)

To find similar documents by classification:

75.140 (Waxes, bituminous materials and other petroleum products Asphalts for building, see 91.100.50 Asphalts for road construction, see 93.080.20)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.