ASTM-D5667 › Historical Revision Information
Standard Test Method for Rubber From Synthetic Sources - Total and Water Soluble Ash
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a test method for the determination of ash content in synthetic rubber.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 These tests are mainly intended for referee purposes but can also be used for quality control of rubber production.
4.2 The total and water soluble ash content of a rubber can affect the properties of compounded, vulcanized rubber such as water absorption, swell, electrical properties, etc.
Keywords
ash; synthetic rubber; total ash; water soluble ash;
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5667-95(2015)
Revision Level
1995 R15 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 1, 2015
Document Type
Test Method
Page Count
2 pages
Committee Number
D11.11