ASTM-D5817 › Historical Revision Information
Standard Practice for Carbon Black, Pelleted-Reduction, Blending, and Drying of Gross Samples for Testing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes the procedure for blending of pelleted carbon black, the procedure for the reduction of gross samples of pelleted carbon black to the appropriate size for testing and the preparation of the sample for testing. These techniques are intended to minimize variations in measured characteristics between test samples. Standard terminology relating to carbon black samples is found in Terminology D 3053.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
carbon black; pelleted carbon black; reducing and blending carbon black; ICS Number Code 71.060.10 (Chemical elements)
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5817-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
Jan. 10, 2003
Document Type
Practice
Page Count
3 pages
Committee Number
D24.61