ASTM-D5897 › Historical Revision Information
Standard Test Method for Determination of Percent Hydroxyl on Cellulose Esters by Potentiometric Titration - Alternative Method
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a procedure for determining the percent hydroxyl on cellulose esters by potentiometric titration. The typical range of percent hydroxyl measured is 0.7 to 10.0 %.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method provides a simpler means for the determination of the hydroxyl content of cellulose esters than the preparation and measurement of the carbanilate derivative described in Test Methods D 817
The hydroxyl content is an important indicator of solubility and reactivity.
Keywords
cellulose esters; percent hydroxyl; potentiometric titration; ICS Number Code 83.080.20 (Thermoplastic materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5897-96(2007)
Revision Level
1996 R07 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
July 1, 2007
Document Type
Test Method
Page Count
4 pages
Committee Number
D01.36