Document Center is acquired by Nimonik

Scope

1.1 This guide covers the selection of procedures commonly used to establish a measurement of horizontal position during investigations of surface water bodies that are as follows:

1.1.1 The narrative specifies horizontal positioning terminology and describes manual, optical, and electronic measuring equipment and techniques.

1.2 The references cited contain information that may help in the design of a high quality measurement program.

1.3 The information provided on horizontal positioning is descriptive in nature and not intended to endorse any particular item of manufactured equipment or procedure.

1.4 This guide pertains to determining horizontal position of a depth measurement in quiescent or low velocity flow.

1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

terminology; equipment; ICS Number Code 13.060.10 (Water of natural resources); 17.020 (Metrology and measurement in general)

To find similar documents by ASTM Volume:

11.01 (Water (I))

To find similar documents by classification:

13.060.10 (Water of natural resources)

17.020 (Metrology and measurement in general Including measuring instruments in general, preferred numbers, standard measures, general aspects of reference materials, etc. Quantities and units, see 01.060 Chemical reference materials, see 71.040.30)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.