ASTM-D5907 › Historical Revision Information
Standard Test Method for Filterable and Nonfilterable Matter in Water
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of filterable and nonfilterable matter in drinking, surface, and saline waters, domestic and industrial wastes. The practical range of the determination of nonfilterable particulate matter is 4 to 20000 mg/L. The practical range of the determination of filterable matter is 10 to 20000 mg/L.
1.2 Since the results measured by this test are operationally defined, careful attention must be paid to following the procedure as specified.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 9.
Keywords
dissolved matter; dissolved solids; filterable matter; nonfilterable matter; suspended matter; suspected solids
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.060.60 (Examination of physical properties of water)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5907-96a
Revision Level
1996A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 10, 1996
Document Type
Test Method
Page Count
6 pages
Committee Number
D19.05