ASTM-D5913 › Historical Revision Information
Standard Test Method for Evaluation of Cleanability of Paint Brushes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a laboratory procedure for the evaluation or comparison of the cleanability of paint brushes, or both, when used with latex paints.
1.2 This test method is applicable to paint brushes up to 100 mm (4 in.) in width and of similar head dimensions as described in Practice D5301.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 The final appearance of a paint brush after it has been used and cleaned is related to the ability of the brush to perform consistently upon repeated use. This test method offers a subjective visual criteria that provides a rank order of cleanability of the filaments of a brush after use.
Keywords
applicator-brush clean-up; cleanability—brush
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.100 (Paint coating equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5913-96(2013)
Revision Level
1996 R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Nov. 15, 2013
Document Type
Test Method
Page Count
3 pages
Committee Number
D01.61