Document Center is acquired by Nimonik

Scope

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see and ). Note 1There is no equivalent ISO standard.

1.3 Order of PrecedenceIn the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

Keywords

diallyl phthalate plastics; epoxy plastics; melamineformaldehyde plastics; molding compounds; phenolic plastics; plastics; polyester plastics; silicone resin molding compounds; ICS Number Code 83.040.01 (Raw materials for rubber and plastics in general)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.040.01 (Raw materials for rubber and plastics in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.