ASTM-D6269 › Historical Revision Information
Solidification Point of P-Xylene, Test Method For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the solidification point of
Note 1—Other test methods for determining freeze point and solidification point of aromatic hydrocarbons include Test Methods D 852, D 1015, D 1016, and D 1493.
1.2 The following applies to all specified limits in this test method: for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.
1.3 This standard does not purport to address all the safety concerns, if any, associated with its use. It is the responsibility of the user of this test method to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7.
Keywords
p-Xylene; solidification point
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
71.080.15 (Aromatic hydrocarbons)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6269-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
New
Publication Date
May 10, 1998
Document Type
Test Method
Page Count
3 pages
Committee Number
D16.04