Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the rate at which water vapor passes through non film forming treatments, such as silanes, siloxanes and blends of silanes/siloxanes applied to cementitious substrates.

1.2 This test method covers the use of the wet cup technique, which most closely approaches the exterior conditions for use for these materials. Other conditions can be used if agreed upon between purchaser and supplier. Agreement should not be expected between results obtained by different methods or test conditions.

1.3 The values stated in SI units of measurement are designated as the standard. Factors for conversion to inch-pound units are given in 9.2.1.1 and 9.2.2.1.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

One of the factors affecting the performance provided by a cementitious treatment is how readily water vapor passes through it. Hence, the water vapor transmission characteristics of treatments are important in assessing their performance in practical use.

The purpose of this test method is to obtain values of water vapor transfer through treatments that range in permeability from high to low. These values are for use in design, manufacture, and marketing.

Water vapor transmission is not a linear function of film thickness, temperature or relative humidity.

Values of water vapor transmission rate (WVT) and water vapor permeance (WVP) can be used in the relative rating of treatments only if the treatments are tested under the same closely controlled conditions of temperature and relative humidity.

Keywords

permeability; permeance; perms; water vapor permeance; water vapor transmission; ICS Number Code 87.040 (Paints and varnishes)

To find similar documents by ASTM Volume:

06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)

To find similar documents by classification:

87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.