Document Center is acquired by Nimonik

Scope

1.1 This practice is used to calculate the mass (commonly expressed in tons) of coal in a storage pile using the volume of the stockpile by Test Method D 6172 and the density of the coal determined by Test Method D 6347/D 6347M.

1.2 This practice is applicable to all ranks of coal.

1.3 The user of this standard determines when the density values provided by the survey require an adjustment for moisture.

1.4 The values stated in either inch-pounds or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems can result in nonconformance with the specification.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

density; stockpile; tonnage; tons; volume; ICS Number Code 73.040 (Coals)

To find similar documents by ASTM Volume:

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

73.040 (Coals Including lignites Coal products, see 75.160.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.