ASTM-D6777 Historical Revision Information
Standard Test Method for Relative Rigidity of Poly(Vinyl Chloride)(PVC) Siding

ASTM-D6777 - 2002 R10(E1) EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Relative Rigidity of Poly(Vinyl Chloride)(PVC) Siding (Withdrawn 2021)
ORDER

Scope

1.1 This procedure describes a method to determine a numerical value indicating the relative rigidity or stiffness of vinyl siding panels. This procedure is not intended for routine quality control inspection during the manufacture of vinyl siding. The rigidity of vinyl siding is believed to be controlled primarily by its configuration and is not believed to be significantly influenced by manufacturing variables.

1.2 Vinyl siding with higher rigidity is often easier to handle and install. It is expected to provide a straighter appearance when installed on walls having an uneven surface.

1.3 All other vinyl siding requirements and test methods can be identified through Specification D3679.

1.4 There is no known ISO equivalent to this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Vinyl siding with higher rigidity is often easier to install and expected to provide a straighter appearance when installed on walls having an uneven surface.

The rigidity of vinyl siding is believed to be controlled primarily its characteristic configuration and is not believed to be significantly influenced by manufacturing variables. Siding weight has little influence on this test.

Keywords

PVC siding; rigidity; rigidity index; Poly(vinyl chloride)(PVC) siding/soffit; Poly(vinyl chloride)(PVC)--specifications; Quality control (QC)--plastics; Rigidity test; Rigid plastics; Stiffness--plastics; ICS Number Code 83.080.20 (Thermoplastic materials)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.080.20 (Thermoplastic materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6777-02(2010)e1

Revision Level

2002 R10(E1) EDITION

Status

Superseded

Modification Type

Reapproval with Ed Change

Publication Date

Nov. 1, 2010

Document Type

Test Method

Page Count

4 pages

Committee Number

D20.24