ASTM-D6840 › Standard Test Method for Effect of Drycleaning on Buttons
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test is a means of determining the effect of drycleaning on certain physical attributes of buttons. The test method applied to buttons made from plastics, natural materials, cast metal, stamped metal and electroplated plastic.
1.1.1 The observed attributes of buttons made from plastic and natural materials include: color change, color transfer, solubility, swelling, and loss of finish.
1.1.2 The observed attributes of buttons made of metal and electroplated buttons include: color change, oxidation and color transfer.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
buttons; formulated drycleaning solvent; ICS Number Code 25.220.10 (Surface preparation)
To find similar documents by ASTM Volume:
07.02 (Textiles (II): D4393 - latest)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6840-02R21
Revision Level
2002 R21 EDITION
Status
Current
Modification Type
New
Publication Date
July 9, 2021
Document Type
Test Method
Page Count
2 pages
Committee Number
D13.54