ASTM-D6862 › Historical Revision Information
Standard Test Method for 90 Degree Peel Resistance of Adhesives
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the relative peel strength of an adhesive bond between one rigid adherend and one flexible adherend when tested at an angle of approximately 90 degrees under specified conditions of preparation and testing.
1.2 A variation in thickness of the adherends will generally influence test values. For this reason, the thickness of the adherends used to make the test specimens shall be specified in the material specification. When no thickness is specified, the flexible adherend shall be 0.63 mm (0.025 in.) thick and the rigid adherend shall be 1.63 mm (0.064 in.) thick.
Note 1—A heavy fabric, such as canvas, has been used as a flexible adherend.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
adhesives; assemblies; bonds; laminates; peel; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6862-11R21
Revision Level
2011 R21 EDITION
Status
Current
Modification Type
New
Publication Date
April 14, 2021
Document Type
Test Method
Page Count
6 pages
Committee Number
D14.10