ASTM-D6875 Historical Revision Information
Standard Test Method for Solidification Point of Industrial Organic Chemicals by Thermistor

ASTM-D6875 - 2008 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Solidification Point of Industrial Organic Chemicals by Thermistor
ORDER

Scope

1.1 This test method covers a general procedure for determining the solidification point of most organic chemicals having appreciable heats of fusion and solidification points between 4 and 41°C.

Note 1—Other test methods for determining freeze point and solidification point of aromatic hydrocarbons include Test Methods D 852, D 1015, D 1016, D 3799, D 4493, and D 6269.

1.2 This test method is applicable to relatively pure compounds only. Solidification point depression is dependent on impurity concentrations.

1.3 The following applies to all specified limits in this test method: for purposes of determining conformance with applicable specifications using this test method, an observed value or a calculated value shall be rounded off to the nearest unit in the last right hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 8, Hazards.

Significance and Use

This test method may be used for process control during the manufacture of organic chemicals described in Section 1, for setting specifications, for development and research work, and to determine if contamination was introduced during shipment.

Keywords

benzene; cyclohexane; p-Xylene; solidification point; Benzene--paints/related coatings/materials; Contamination--paints/coatings applications; Cyclohexane; Organic chemicals; Process control; Solidification point; para-Xylene; ICS Number Code 71.080.01 (Organic chemicals in general)

To find similar documents by ASTM Volume:

06.04 (Paint -- Solvents; Aromatic Hydrocarbons)

To find similar documents by classification:

71.080.01 (Organic chemicals in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6875-08

Revision Level

2008 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Oct. 1, 2008

Document Type

Test Method

Page Count

4 pages

Committee Number

D16.04