ASTM-D6932 Historical Revision Information
Standard Guide for Materials and Construction of Open-Graded Friction Course Plant Mixtures

ASTM-D6932 - 2008 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Guide for Materials and Construction of Open-Graded Friction Course Plant Mixtures
ORDER

Scope

1.1 This guide covers the construction of bituminous open-graded friction course plant mixtures. End-use specifications should be adopted to conform to job and user requirements. Where applicable, Specification D 3666 should be applied as a minimum for agencies testing and inspecting road and paving materials.

1.2 Bituminous open-graded friction courses are placed as the final wearing course for highways and airfields.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Significance and Use

p>This guide provides information to assist engineers with the design requirements and construction guidelines for paving an Open-Graded Friction Course (OGFC) surface layer. An OGFC is primarily used to improve the skid resistance and wear resistance of a bituminous pavement by providing an escape route for surface water beneath a moving wheel load. The mixture is typically produced with a low amount of fine aggregate particles and high air void content to provide a passageway of interconnected voids for moisture to drain away from the travelway. The film thickness of the asphalt and overall asphalt content is important for better stripping resistance and durability and aging properties.

Note 1—OGFCs may also be placed to reduce the tire-pavement interface noise and may also be placed to reduce the occurrence and severity of reflective cracking.

Keywords

asphalt cement; asphalt rubber; modified asphalt cement; open-graded friction course; Asphalt cements; Open graded friction; ICS Number Code 93.080.20 (Road construction materials)

To find similar documents by ASTM Volume:

04.03 (Road and Paving Materials; Vehicle-Pavement Systems)

To find similar documents by classification:

93.080.20 (Road construction materials Including asphalts, road pavements, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6932/D6932M-08

Revision Level

2008 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Aug. 1, 2008

Document Type

Guide

Page Count

4 pages

Committee Number

D04.23