ASTM-D711 › Standard Test Method for No-Pick-Up Time of Traffic Paint
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This test method covers a laboratory procedure for determining the no-pick-up time of a traffic paint. The method uses a wheel consisting of a metal cylinder with rubber O-rings. The wheel is rolled down a ramp over a freshly applied traffic paint film repeatedly until there is no transfer of paint to the rubber rings. The elapsed time from paint film application to point of no paint transfer is the no-pick-up time. Key variables to be controlled during testing are film thickness, temperature, humidity, and air flow.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
auto no-track time; drying time; no-pick-up time; traffic paint;; ICS Number Code 87.040 (Paints and varnishes); 93.080.30 (Road equipment and installations)
To find similar documents by ASTM Volume:
To find similar documents by classification:
93.080.30 (Road equipment and installations Including road traffic warning and control systems, devices and installations (speed controls, traffic signal installations, vehicle loop detectors, pavement markers, manholes, etc.))
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
2010 R15 EDITION
June 15, 2015